hero image

Atlas 9KBP


The Atlas 9KBP is a base-plate two-post lift designed for low ceiling garages. The total column height of 111 ½" (9 feet 3 ½ inches) allows this lift to be installed in almost any professional or home garage with a ceiling as low as 9 feet 6 inches.

More Details:

Symmetric Columns and Arms: The Atlas 9KBP includes asymmetric column configuration to offer the widest possible Drive-Thru. The Atlas 9KBP baseplate above ground lift has symmetric arms to allow easy access to both sides of the vehicle. The Atlas 9KBP also includes two additional lifting pads that offer an infinite amount of lifting points for the rear lift arms.

The Atlas 9KBP has the chain-over-roller cylinder configuration. The base plate two posts above ground lift implement the chain-over-roller configuration. This is the only hydraulic cylinder system that is possible in the base plate lift. The base plate two post above ground is designed for "low ceilings". The direct-drive hydraulic cylinder configuration cannot be used in the base plate lift because the hydraulic cylinder would extend above the 9' 3" column when the lift arms were raised to the maximum height.

The "overhead" two posts above ground lift may incorporate either the direct drive hydraulic cylinder or the chain-over-roller hydraulic cylinder.


Capacity: 9,000 lbs
Overall Height 111 ½" (9' 3 ½")
Overall Floor Width 134 ½" (11' 2 ½")
Outside Column to Outside Column 124 7/8" (10' 4 7/8")
Maximum Lift Height 74 ½" (6' 2 ½")
Minimum Pad Height 4"
Base Plate Width 10 ¾"
Inside Column 110" (9' 2")
Drive Thru 101" (8' 5")
Column Size 7 1/4" x 11 1/8"
Column Thickness of Steel 5 gauge (.2", 5.08mm)
Cable Diameter .375"
Base Of Lift 13 ½" x 18 ¼"
Motor / Power Supply: 2.5HP 220 volt single (1) phase. A 30 amp breaker is recommended.
Ship Weight: 1,40 lbs
Lift Speed: Ask Your Salesperson